The TTU-205 and FLMTS pressure-vacuum pump consists of two-piston-type pumps in common aluminum alloy housing. An electric motor drives both the pressure and vacuum sides of the pump. This pump is used to provide pressure and vacuum source for various ground support air data test equipment. The pump requires routine servicing and TestVonics has all the parts necessary to maintain, service, anr/or repair these pumps.
| • |
Pump Parts - we carry an array of parts for these pumps, in addition to servicing and overhauling pumps. Call today for a quote. |
| • |
Service Life Extension Kit - The SLEK (P/N: 225600) program was adopted to reduce cost for pump maintenance. The SLEK takes only minutes to install and replaces the entire center body of the pump, eliminating the need for extensive teardown. No longer are technicians required to perform difficult tasks such as pressing out sleeves, removing and replacing rings and other piece parts. It was also determined that many pump bodies were well past there expected service life. The SLEK program has shown its value repeatedly, its reliability and support readiness have dramatically improved since its implementation. |
| • |
1000 hour Maintenance Kit - routine servicing of the pump consists of periodic installation of the parts in the 1000-hour maintenance kits (P/N: 225635). This kit is installed every 1,000 hours of use. |
| • |
1500 hour Maintenance Kit - This is a 1,500 Hour Maintenance Kit (P/N: 225640) was procured regularly until being replaced by the SLEK program. This kit has many more parts than the 225635 kit and increases the maintenance cycle from 1,000 to 1,500 hours. |
|
